ACDSee Pro 3 Beta - Bugs

Back to Topic OverviewPost New Reply

Several display bugs in Process mode

[closed] (1 post)
  • Started by noam
  • Started on June 26, 2009 - 06:29 AM (4 months ago)

  • noam
    Focus Group

    I have encountered several display bugs which were not evident in pre-public beta builds.

    1. When enabling/bypassing a processing section in Develop mode (by clicking the corresponding green square checkbox), the preview image doesn't change. It happens in both directions, i.e., when either bypassing or enabling. Only if I click the checkbox two more times does the image get updated. So my workaround is two quickly triple-click the checkbox. This bug occurs almost all the time, and it applies to all processing sections.

    2. In both Develop and Edit process modes, sometimes the preview image zooming controls disappear (I'm talking about the controls in the lower-right part of the display - the slider, magnification drop-down list, and 1:1, navigation, and fit buttons). It reappears when I switch to another processing function.

    3. When using the Resize function in Edit, the preview display goes funky in many unpredictable ways, especially with regard to the preview image zoom controls: Both the Fit and 1:1 buttons do not function as expected, the button for navigating the image (the one to the left of the magnification slider) disappears, and the image scrollbars do not function properly as well. Also, in one occasion, after I doubled the size of the image, the preview image (which was zoomed out to fit in the window) was degraded to the low resolution of the zoomed-out preview. If I then tried to zoom in, larger square pixels were observed.

     

    Best,

    Noam

    Posted On June 26, 2009 - 06:29 AM (4 months ago) (Permalink to this post)

Subscribe to this topic via RSS

Topic Closed

This topic has been closed to new replies.