New Content Since Last Visit
No New Content Since Last Visit
Hello, this is my first post.
When I finish my editing in Pro 3 i go to file and save my image as save as and put a few numbers or letters to finalize my image. When I click on the x to get out a box appears asking me to click on save-save as etc. I clixk on save and my original is lost. How can I correct this problem?
Thanks.
Could you repost your question in a separate thread? The short answer is, with ACDSee Pro 3, if you use Develop mode (as I assume you are), you don't need to hit Save at all - everything is *automatically* saved, and your original is kept perfectly safe too. But if you are doing something special where you can't use Develop mode or need to use Save As rather than depend on the automatic non-destructive editing, then again, please start a new thread and describe in more detail what your special circumstances are.
After I finish editing my phot I go to file and click on save as. I then enter a set of numbers in the file name box and click save. When I try to exit out of the system a box appears asking me to save changes and I click on save as. My original photo is gone after this and replaced with my edited photo. What am I doing wrong? Thanks!
